Description
HOW TO USE
PREPARATION OF THE SUPPORT: can be applied on all concrete, cement screed or mortar surfaces, mechanically polished or not.
The application is possible for both new and existing concrete floors. The treatment must be carried out on concrete that has been cured for at least 28 days, with the surface thoroughly cleaned and dry to the touch. Mechanically remove from the surface any traces of membrane residues, film treatments and seal the cracks or restore the damaged areas.
Sealants, oil, grease, dirt, dust and residues must be removed beforehand, taking care to eliminate any residue that could prevent the correct penetration of the product. For basic washing, use BETON REFRESH or CEMENT CLEANER, non-caustic alkaline degreasing detergents, or ZERO OIL to eliminate heavier dirt. Then, on a completely clean and dry surface, proceed with the treatment.
PREPARATION OF THE SUPPORT: LI-PLUS is ready to use and does not require dilution.
APPLICATION: apply LI-PLUS in a thin and uniform layer until the substrate is completely covered, use a low pressure sprayer for the application and even out with a wax spreader or fleece with a microfibre pad, taking care to spread out any accumulations of product. Where necessary, an additional application is possible. The drying time is estimated at about 2/3 hours, it can vary depending on the humidity, after which the floor will be accessible.
However, the reaction may take up to four weeks to complete, so it is recommended to wait one day after application before accessing the surface, also avoid wetting it for at least 7-10 days and avoid staining substances falling during this period. Avoid contact with surfaces for which the product is not intended, in the event that the product comes into contact with: glass, fabrics, metal or painted surfaces, immediately clean the affected parts with a cloth dampened with water and then dry with a clean cloth.
| PHYSICAL PROPERTIES | |
|---|---|
| Property | Modified lithium-potassium silicate |
| I wait | Liquid |
| Odor | Odorless |
| Combustibility | Incombustible |
| Density | 1.04 g/cm³ |
| Applied amount needed | 0.2-0.4 kg/m² |
| Maturing time | 20-30 days (accessible after a few hours) |
ATTENTION
The treatment is to be considered for internal use, do not apply at temperatures below 5°C and, in case of very hot temperatures, it may be useful to moisten the surface with water beforehand, to prevent the product from drying too quickly. If the product is applied in a very cold or humid environment, these conditions would slow down the drying of the treatment. Make sure you have the latest update of the technical data sheet and the safety data sheet, please read the information contained therein before use.
STORAGE
The product must be stored in the original containers, hermetically sealed, at temperatures between 10°C and 30°C, protected from direct sunlight and in ventilated areas. In these conditions the product has a shelf life of 12 months from the date of the delivery note, if the material is kept in storage beyond the recommended stability period it will not necessarily be considered unusable but a preventive check on the product must be carried out.