Description
HOW TO USE
SURFACE PREPARATION: the product is applied on mineral surfaces such as cement, concrete, marble and wood. In the case of application on absorbent mineral surfaces, a preliminary coat of the product diluted to 20% is required as a primer. Concrete surfaces: make sure that the surface is clean, dry, free from grease, grease and contaminating material; any oil stains must be previously removed by washing with the specific ZERO OIL detergent. If necessary, sand and vacuum the surface.
PRODUCT PREPARATION: mix with a drill equipped with a stirrer, at low speed, until a homogeneous solution free from foam is obtained.
Mix the two components in a ratio of 3 parts of component A with 1 part of component B (mixing ratio 3:1) then apply uniformly to the surface within 15 minutes using a suitable wax spreader or short-haired roller (MOHAR) or with an airless spray pump. Plan to apply two coats of product. Mix only the quantities that can be used within the maximum workability time.
APPLICATION
apply POLYLUX FINISH at temperatures above 10°C. Do not apply under direct sunlight, wind, fog or rain. The product is sensitive to frost.
TOOL CLEANING
The equipment used must be cleaned immediately after use with plenty of running water. Once the product has hardened, removal can only be carried out mechanically.
INDICATIVE COVERAGE
1Kg every 9-11 m2
STORAGE
Storage 12 months, if stored in well-closed containers and in a cool, dry place with a temperature between +10°C and +25°C.