PREPARATION OF THE SUPPORT: the treatment must be carried out on concrete that has been cured for at least 28 days, with the surface thoroughly cleaned and dry to the touch. Mechanically remove from the surface any traces of membrane residues, film treatments and seal the cracks or restore the damaged areas.
Sealants, oil, grease, dirt, dust and residues must be removed beforehand, taking care to eliminate any residue that could prevent the correct penetration of the product; for basic washing use CLEAN SPECIAL non-caustic alkaline degreasing detergent, then apply the treatment on a completely clean and dry surface.
PREPARATION OF THE SUPPORT: at the time of use, the product can be diluted with distilled water in a ratio of 1:1.

APPLICATION: once the mixture is obtained, apply with: low pressure sprayer, impregnated roller, rubber spatula, wax spreader or other suitable applicator, the product must be applied wet on wet in two coats spaced about 5-15 minutes apart, depending on the room temperature, until complete saturation is achieved. It is recommended to be careful to avoid the formation of dry areas during the treatment. Complete saturation is obtained after about 20-30 minutes. If a gelation begins to form on the surface, it is advisable to remove the excess product that has not been absorbed, otherwise unsightly results could occur.
The treatment is to be considered for internal use, do not apply at temperatures below 5°C and, in case of very hot temperatures, it may be useful to moisten the surface with water beforehand to prevent the product from drying too quickly. If the product is applied in a very cold or humid environment, these conditions will slow down the drying of the product; if after an hour from application the flooring is too wet, it is advisable to wash the surface with an automatic floor cleaner to remove excess product.